FAQs

---

Why are only some measurements output when the system is turned on?
How long will it take after power-up before the accuracy specification of the RT3000 is met?
What is the average time to initialise the RT3000 after power-up?
Is there any way to force the system to initialise while in the office so I can test my own software?

Why is there is no data on my CAN bus?
My RT3000 does not have all the messages on the CAN bus. Why?
Do I need to place the RT3000 at the Centre of Gravity?
Why does the Slip Angle accuracy depend on speed?
How does the RT3000 measure slip angle?
Can you supply extended measurement ranges for the RT3000?
How often does the RT3000 require calibration or recalibration?
Can I monitor the performance of the RT3000 system so that I know when it is working?
Does the performance of the RT3000 change when the number of GPS satellites is reduced?
What is the bandwidth of the measurements from the RT3000?
Why does the RT3000 Pitch and Roll not drift with time like other, conventional stabilized platforms?
Does the Output Displacement option displace all the signals or only some?
What are the additional files that are created when post-processing?

Why does no one supply a standard CAN bus cable?
How long can my CAN bus cable be?
How do I connect my CAN bus?
Why is there no Slip Angle message output by the RT?

Do you have an overview of the different GPS modes and accuracies?
Can I use my Dual-Antenna system in Single-Antenna mode?
What benefits does a Dual-Antenna system have?
Do you have an overview of inertial navigation?
How do I avoid IMU Reset Problems
How do I identify which processing platform is in my RT?
How do I use OmniStar with my RT?

Copyright © 2013 OXTS - Oxford Technical Solutions